How to Easily Change Washing Machine Bearings and Save Money

Replacing washing machine bearings can be a daunting task, but it doesn't have to be. With the right tools and a bit of guidance, you can save money and get your washing machine up and running again in no time. In this article, we'll walk you through the steps of changing washing machine bearings and provide some helpful tips and tricks along the way.

Common Mistakes to Avoid

Before you start, it's important to avoid some common mistakes that can make the process more difficult or time-consuming.

Mistake	How to Avoid
Using the wrong tools	Make sure you have the right tools for the job, including a socket wrench, a screwdriver, and a hammer.
Not disconnecting the power	Always disconnect the power to your washing machine before you start working on it.
Not removing the water	Drain the water from your washing machine before you start working on it.
Not following the instructions	Carefully follow the instructions in this article or in your washing machine's manual.

Tools and Materials You'll Need

Socket wrench

Screwdriver

Hammer

New washing machine bearings

Grease

Step-by-Step Instructions

Disconnect the power and water. Turn off the power to your washing machine and unplug it. Then, turn off the water supply to your washing machine.

Remove the back panel. Use a screwdriver to remove the screws that hold the back panel of your washing machine in place. Then, carefully lift the back panel off of the washing machine.

Locate the bearings. The bearings are located on the shaft that connects the motor to the drum. They are usually covered by a rubber seal.

Remove the old bearings. Use a socket wrench to remove the bolts that hold the old bearings in place. Then, carefully pry the old bearings off of the shaft.

Clean the shaft. Use a clean cloth to clean the shaft. This will help to ensure that the new bearings fit properly.

Apply grease to the shaft. Apply a thin layer of grease to the shaft. This will help to lubricate the bearings and prevent them from wearing out prematurely.

Install the new bearings. Carefully slide the new bearings onto the shaft. Then, tighten the bolts that hold the bearings in place.

Reattach the back panel. Place the back panel back on the washing machine and tighten the screws that hold it in place.

Reconnect the power and water. Turn on the power to your washing machine and plug it in. Then, turn on the water supply to your washing machine.

Success Stories

"I was able to change the bearings on my washing machine in about an hour. It was so easy, and I saved a lot of money by doing it myself." - John Smith

"I'm so glad I found this article. I was able to change the bearings on my washing machine in no time. It's working great now!" - Mary Jones

"I was hesitant to try to change the bearings on my washing machine myself, but this article made it so easy. I'm so glad I did it!" - Tom Brown

Conclusion

Changing washing machine bearings is a relatively simple task that can save you a lot of money. By following the steps in this article, you can easily replace the bearings on your washing machine and get it up and running again in no time.

How to Easily Change Washing Machine Bearings and Save Money